What do turns on a motor mean

So, if you need more turns inside the motor, you need to add thinner wire inside the motor. On the contrary, the thicker wire makes only a few amounts of turns. Thus, a The abbreviation of the RPM is revolutions per minute. It means a motor with a Kv may spring at RPM per minute when it powers for one volt. Similarly, the Kv motor can spin at RPM at one-volt power.

This is why we can say that the Kv rating of a device and motors turns are interrelated with each other. You should always remember that the higher RPM means the short-lasting of the battery power, as it is faster and takes more power per minute.

The Kv refers to the unloaded motor that can spin freely. Of course, a higher Kv motor works faster than the low Kv motor at the same voltage. It is prevalent for the RC lovers to become confused about a new brushless motor for the RC vehicle.

They think from which my car can be interpreted by turns or by Kv rating. In this case, you should remember the following points to know what turns on an RC motor is. The Turns is the physical trait of a motor, while Kv is like horsepower. The turns indicate how much wire is being wrapped inside the motor. The higher numbers of turn mean more wire power with more resistance, which results in a slower quality motor. Thus, the turns with a fewer number states that you have a faster speed motor.

The turn rating is taken as an inverse proportional to the power that occurred by the motor. You should always look at the turns and RPM in a simple manner. If you remember to look at it in a simple manner, you will always know that a 4. The Kv is related to the motor power supplied outer from the motor. This is why it would be best if you choose the right turn rating for your RC vehicle. Lower T values, like 4. Yeah ok, the Radio too. With so many choices out there, and different ways to measure the rating of these motors, you can find yourself going bug-eyed and want to hit your head on the desk out of confusion and frustration.

I myself was wondering, if I were to get a different setup, what would I get. Do I want to keep top speed, or get more torque. How do I tell the difference between the two?? Turns, KV. Here is a chart that I made based on hours of research and best accurate information from the manufactures. Here is what I am looking at. Data collected based on a 7. Part LRP According to the chart with best accuracy comparing the 3 types, and rating system. Minus the fact DuraTrax is not a censored system.

The only extreme is the Mamba 7,Kv system. Other systems may not use this type of chart. The reason I wanted a little reference chart like this is so When I read about a turn, and then a KV rating. I can see where the correlation is between them. I also can better judge the price. I know there are a lot of determining factors when it comes to the Turns of a motor, and why. With a little understanding on where each system sits and on what scale to one another, you can determine yourself what your up against when looking at systems across the board.

With in reason of course. The extremes in number or turns The calculations for turns given kV and kV given turns should be somewhat independent of the battery voltage but the wattage is not. Hey but thats for brushed. Theres no armature in a brushless only a rotor magnets and the wiring isnt in the middle. Actually to think of it the insides of the two different motors are inveretrd so where armature and winding is its a magnet and so onare.

Turns are how many times the wire is wrapped around the armature. The fewer turns usually the higher KV is. More Turns e. Slower but easier to drive. Less Turns e. First you have to find out what you want. What speed and runtime do you want to achieve? The above questions need to be answered before picking the correct motor.

Note: This article is a copyright of asiatees. For original article, please click HERE. Below gives you a general idea of the amount of Turns being generated to RPM: 3. Unit Price:. Guaranteed safe Checkout.